installing your washer
STEP 2
Connecting the water and the drain
Connecting the water supply hose
To avoid leaks, make sure that your water supply hoses CAUTION have rubber seals at both ends. Please make sure to use
new water supply hoses to connect to the water faucets. Do not reuse old hoses. Only use new hoses when you install the washing machine. Old hoses could leak or burst causing fl ooding and property damage.
When you initially install the washer, be sure to use a new |
|
CAUTION hose. Failing to do so may result in a water leakage or |
|
overfl ow and may damage your property. |
Do not connect multiple water supply hoses. This may CAUTION result in a water leakage and electric shock due to the
water leakage. If the hose is too short, replace the hose with a longer, high pressure hose.
1.Connect the ends of the water supply hoses to the HOT and COLD faucets.
2.Tighten the fi tting by hand until it is snug, then make
When you fasten the fi tting, do not fasten it excessively or apply tape CAUTION or sealant to the faucet or water supply intake. This may damage the
fi tting.
After you have connected the water supply hose to the faucet, ensure that it is connected correctly by pulling the water supply hose downwards.
3.Prepare a bucket for the water that will be emitted when you open the faucets connected to the two water supply hoses to remove any foreign substances from them.
4. Connect the ends of the water supply hoses to the water supply intake connections at the back of the washer.
The water supply hose connected to the HOT faucet must be CAUTION connected to the hot water supply intake and the water hose
connected to the COLD faucet must be connected to the COLD water supply intake.
Rubber Seals
Cold Hot
16_ installing your washer
