Samsung WA484DSHASU Connecting the drain hose, Laundry tub, Minimum capacity 20 gal Liter

5. Tighten the fi tting by hand until it is snug, then make two-thirds of a turn with a wrench.

To ensure the correct water usage, connect both the HOT and COLD water faucets. If either or both are not connected, an “nF” (no fi ll) error can occur.

Check if the water supply hose is not twisted or bent. If the CAUTION hose is twisted or bent, there is a danger of a water leakage and

electric shock due to the water leakage.

6.Turn on the HOT and COLD water supplies and check all the water supply intake connections and the faucets for water leaks.

01 installing your washer

Connecting the drain hose

Drain can be installed using method you need.

1.fl oor standpipe

-Minimum diameter for a standpipe drain: 2” (51 mm).

-Minimum carry-away capacity: 17 gal. (64 Liter) per minute.

-Top of standpipe must be at least 39” (990 mm) high, install no higher than 96” (2.4 m) from bottom of washer.

-If you must install higher than 96” (2.4 m), you will need a sump pump system.

Stand pipe

Hose retainer

4”

(100 mm)

39” Min (99 cm)

Tie strap

2.laundry tub.

-	Minimum capacity: 20 gal. (76 Liter).				Hose
			(100 mm)		retainer
			4”
-	Top of laundry tub must be at least 39” (990 mm) above fl oor.
		96” Max
		39” Min
-	Install no higher than 96” (2.4 m) from bottom of washer.			Tie strap

3. Over the edge of a wash basin

- Secure the guide to the side of the basin wall with a hook or to the tap with a piece of string to prevent the drain hose from moving.

Make sure that the connection between the drain hose and the standpipe is not airtight.

installing your washer _17

WA484DSHA-03050D_EN.indd Sec3:17

2012-07-02 ￿￿ 3:39:20