Code | Action | |
|
| |
| Laundry needs protection because the water being supplied is | |
| too hot. | |
4C2 | • Make sure the cold and hot water taps are properly | |
connected. | ||
| ||
| • Power off and power the machine on after | |
| then try again. | |
|
| |
| Check the drain system. | |
5C | • Make sure the drain filter is not clogged. | |
• If the drain filter is clogged, clean the filter and restart the | ||
| ||
| machine. | |
|
| |
| Check the washing heater. | |
HC | • Power off and power the machine on after | |
| then try again. | |
|
| |
| Check the drying heater. | |
HC2 | • Power off and power the machine on after | |
| then try again. | |
|
| |
| Check the spinning process. | |
| • The load may not be balanced inside the drum. Check the | |
Ub | drum and make sure the load is balanced. | |
| • Press START/PAUSE to resume operation, or power off and | |
| power the machine on after | |
|
| |
| Check the MEMS sensor. | |
8C, 8C1, 8C2 | • Power off and power the machine on after | |
| then try again. | |
|
| |
OC | Water may overflow. | |
• Close the water valve and call for service. | ||
| ||
|
| |
| Check the motor. | |
3C | • Power off and power the machine on after | |
| then try again. | |
|
| |
| Check the PBA communication status. | |
AC6 | • Power off and power the machine on after | |
| then try again. | |
|
| |
| The Add Door is open. | |
DDC | • Close the Add Door and press START/PAUSE to resume | |
| operation. | |
|
|
Troubleshooting
English 59
|
| 5/23/2016 5:56:17 PM | |
|
| ||
|
|
|
|