Washing a Load of Laundry
Using delay start
You can set the washing machine to finish your wash automatically at a later time, choosing from 3 to 19 hour delay (in 1 hour increments). Displayed hours means the time of finished
To do this:
1.Manually or automatically set your washing machine for the type of clothes you are washing.
2.Press the Delay Start button repeatedly until the delay time is set.
3.Press the Start/Pause button. The Delay Start indicator will light, and the clock will begin counting down until it reaches your finish time.
4.To cancel Delay Start, press the 
(On/Off) button, then turn the washing machine on again.
Drying a load of Laundry
Drying heater heat air to proper temperature and blow through laundry. Then, High and drying air absorb moisture and go into condensing duct which is low temperature environment. So high temperature, moisture air change low temperature and moisture condensed to water. the water is pumped to outside of washing machine.
Washing for the first time
Before washing clothes for the first time, you must run a complete cycle without clothes.
To do this: |
| ||
1. | Press the (On/Off) button. |
| |
2. | Pour a little detergent into compartment ( ) in the |
| |
3. | detergent drawer. | A | |
Turn on the water supply to the washing machine. | |||
| |||
4. | Press the Temperature button repeatedly until 40 ˚C is |
| |
5. | displayed. |
| |
Press the Start/Pause button. |
| ||
•This will remove any water from the manufacturer’s test run
remaining in the machine.
Dispenser 
: Detergent for prewash or starch.
Dispenser 
: Detergent for main wash, water
Dispenser 
: Additives,e.g.fabric softener or former (fill no higher than lower edge of insert“ A”)
Putting detergent in the washing machine
1.Pull out the detergent drawer.
2.Add laundry detergent into compartment (
).
3.Add softener into compartment (
) (if you desire).
4.Add prewash detergent into compartment (
) (if you desire).
Caution :
Concentrated or thick fabric softener and conditioner must be diluted with a little water before being poured into the dispenser (prevents the overflow from becoming blocked.
