![](/images/new-backgrounds/1275212/275212119x1.webp)
Troubleshooting
Troubleshooting
Problem |
| Action |
| |
|
|
| ||
| • Plug the power cord into a live electrical outlet. |
| ||
| • Check the fuse or reset the circuit breaker. |
| ||
| • Close the door and press and hold Start/Pause (Hold to Start) | |||
|
| to start the washing machine. For your safety, the washing | ||
|
| machine will not tumble or spin unless the door is closed. | ||
| • | Before the washing machine starts to fill, it will | make a series | |
|
| of clicking noises to check the door lock and does a quick | ||
Stops. |
| drain. |
| |
• There may be a pause or soak period in the cycle. Wait briefly | ||||
| ||||
|
| and the washing machine may start. |
| |
| • Make sure the mesh filter of the water supply hose at the | |||
|
| water taps is not clogged. Periodically clean the mesh filter. | ||
| • | If the washing machine is not supplied with sufficient power, | ||
|
| the washing machine temporarily will not drain or spin. As | ||
|
| soon as the washing machine regains sufficient | power, it will | |
|
| operate normally. |
| |
|
|
| ||
| • Fully open both taps. |
| ||
| • Make sure the temperature selection is correct. |
| ||
| • Make sure the hoses are connected to the correct taps. Flush | |||
|
| water lines. |
| |
| • Make sure the water heater is set to supply a minimum 120 °F | |||
|
| (49 °C) hot water at the tap. Also, check the water heater | ||
|
| capacity and recovery rate. |
| |
Fills with the wrong | • Disconnect the hoses and clean the mesh filter. The mesh | |||
| filter may be clogged. |
| ||
water temperature. |
|
| ||
• | While the washing machine fills, the water temperature may | |||
| ||||
|
| change as the automatic temperature control feature checks | ||
|
| incoming water temperature. This is normal. |
| |
| • | While the washing machine fills, you may notice just hot and/ | ||
|
| or just cold water going through the dispenser when cold or | ||
|
| warm temperatures are selected. This is a normal function | ||
|
| of the automatic temperature control feature as the washing | ||
|
| machine determines the water temperature. |
| |
|
|
| ||
| • Use the High or Extra High spin speed. |
| ||
Load is wet at the | • | Use high efficiency (HE) detergent to reduce oversudsing. | ||
• Load is too small. Small loads (one or two items) may become | ||||
end of a cycle. | ||||
| unbalanced and not spin completely. |
| ||
|
|
| ||
| • Make sure the drain hose is not kinked or clogged. | |||
|
|
|
|
60 English
2018/2/1 13:19:32