Samsung WF457ARGSGR Connecting the water and the drain, Connecting the water supply hose

STEP 3

Connecting the water and the drain

Connecting the water supply hose

Do not connect multiple water supply hoses. This may result in a water leakage and electric

CAUTION shock due to the water leakage. If the hose is too short, replace the hose with a longer, high pressure hose.

1.Connect one end of the COLD water supply hose to the

COLD water supply intake at the back of the washer.	Cold	Hot
2. Tighten part (A) by hand until it is snug, then make two-
thirds of a turn with a wrench.

3.On the other end of the hose, check for one rubber washer

per hose and install each water supply hose to the faucet.	Rubber
	Washer

Make sure the hose with the printed word HOT is attached to the HOT faucet.

4.Tighten part (A) by hand until it is snug, then make two- thirds of a turn with a wrench.

For the correct water use, connect both the HOT and COLD water faucets. If either or both are not connected, an “nF” (no fi ll) error can occur.

After you have connected the water supply hose to	A
the faucet, ensure that it is connected correctly by
pulling the water supply hose downwards.

Check if the water supply hose is not twisted or bent.

WARNING If the hose is twisted or bent, there is a danger of a water leakage and electric shock due to the water

leakage.

5.Turn on the HOT and COLD water supply and check all connections at the water intake and the faucet for leaks.

01 INSTALLING YOUR WASHER

Installing your washer _21

WF457ARG-03153A-04_EN.indd 21 2012-08-31 ￿￿ 12:30:21