Problem | Action |
|
|
|
|
| • Plug the power cord into a live electrical outlet. |
|
| • Check the fuse or reset the circuit breaker. |
|
| • Close the door and press and hold Start/Pause (Hold to Start) |
|
| to start the washing machine. For your safety, the washing |
|
| machine will not tumble or spin unless the door is closed. |
|
| • Before the washing machine starts to fill, it will make a series |
|
| of clicking noises to check the door lock and does a quick |
|
Stops. | drain. |
|
• There may be a pause or soak period in the cycle. Wait briefly |
| |
|
| |
| and the washing machine may start. |
|
| • Make sure the mesh filter of the water supply hose at the |
|
| water taps is not clogged. Periodically clean the mesh filter. |
|
| • If the washing machine is not supplied with sufficient power, |
|
| the washing machine temporarily will not drain or spin. As |
|
| soon as the washing machine regains sufficient power, it will |
|
| operate normally. |
|
|
|
|
| • Fully open both taps. |
|
| • Make sure the temperature selection is correct. |
|
| • Make sure the hoses are connected to the correct taps. Flush |
|
| water lines. |
|
| • Make sure the water heater is set to supply a minimum 120 °F |
|
| (49 °C) hot water at the tap. Also, check the water heater |
|
| capacity and recovery rate. |
|
Fills with the wrong | • Disconnect the hoses and clean the mesh filter. The mesh |
|
filter may be clogged. |
| |
water temperature. |
| |
• While the washing machine fills, the water temperature may |
| |
|
| |
| change as the automatic temperature control feature checks |
|
| incoming water temperature. This is normal. |
|
| • While the washing machine fills, you may notice just hot and/ |
|
| or just cold water going through the dispenser when cold or |
|
| warm temperatures are selected. This is a normal function |
|
| of the automatic temperature control feature as the washing |
|
| machine determines the water temperature. |
|
|
|
|
| • Use the High or Extra High spin speed. |
|
Load is wet at the | • Use high efficiency (HE) detergent to reduce oversudsing. |
|
• Load is too small. Small loads (one or two items) may become |
| |
end of a cycle. |
| |
unbalanced and not spin completely. |
| |
|
| |
| • Make sure the drain hose is not kinked or clogged. |
|
|
|
|
| English | 55 |
Troubleshooting
|
| 2018/2/7 14:06:18 | |
|
| ||
|
|
|
|