Attach Lower Cord Hook
Insert the power cord into the lower cord hook (A), as shown. Snap the hook into the lower handle. Pull up on the cord to tighten but leave enough slack near the base so the cord is not strained when the handle is lowered.
Attach Upper Cord Hook
Pull the spring on the electrical cord upward toward the top of the handle. Make sure slots in handle are positioned properly, see Detail B.
Insert the lower half of the spring into the upper cord hook, as shown. Snap the hook into the upper handle, directions below.
1. Place | 2. Press hook | 3. SNAP opposite |
inner tab | around | inner tab into |
into slot | handle | place |
Cord Storage
Wrap the cord around the two cord Fasten the plug to the cord to prevent unwinding
Hook Bag Top
Slip the ring at the top of the cloth bag over the bag support hook on the back of the cord hook.
A
8
