Brush Roll Belt
The brush roll belt on the upright vacuum cleaner drives the brush to agitate, sweep, and comb the carpet nap. The belt should be checked regularly to be sure it is in good condition. Replace the belt if it is stretching, cracking, or slipping. Cut away any hair or thread wound around the brush roll or the belt pulley because the buildup could cause the belt to rotate unevenly.
How To Replace A Worn Belt
NOTE: Turn off the switch and unplug the electrical cord before replacing belt. Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.
IMPORTANT: Improper installation of the brush roll or brush roll belt could cause carpet or cleaner damage.
1 1
2 Motor 
Pulley
1.Release cam locks and remove bottom plate.
Belt
Guide
4 3
2.Pull up on belt to rotate it off the motor pulley. Lift up on brush roll and remove worn belt.
5 |
6
Check for brush wear (see Brush Roll instructions).
3.Place new belt around brush roll.
4.Align brush roll pulley with belt guide.
7
7.Place lower side of belt into belt guide and pull to stretch the belt around the left side of motor pulley. Rotate pulley to secure belt into groove.
Ask for GENUINE EUREKA replacement belts, No. 52100
5.Place rubber end cap covers over both end caps (flat side against end cap). Align the holes and secure. Then, slant brush roll forward so end caps are in line with slots in cleaner base.
6.Push brush roll into place.
9 9
88
8.Place slots of bottom plate over tabs of cleaner base.
9.Seat and secure cam locks.
Look for the EUREKAGENUINEPRODUCT symbol.
13
