1: Preparation
1- 1: New Installations
If you have purchased a Sanus Systems large VisionMount™ Full Motion Mount, but have not installed it, begin by following the large VisionMount™ Full Motion Mount instructions. Replace Cross Tube Installation with Step 2: Cross Tube Installation of the LAS1A instructions. When completed, refer back to this Instruction manual, starting at Step 3: Install Extension Tubes.
1- 2: Existing Installations
[25]
NOTE
All graphics in this section are generic and are only used to illustrate a procedure.
Disconnect all electrical connections and release all cables from any cable tie downs. Remove the safety bolt [A] as shown.
Lift the TV and arm assembly [B] off the wall plate [C] as shown Lean the assembly against a wall or other vertical surface.
HEAVY! You will need assistance with this step.
[D]
Using an Allen Key, loosen the six vise assemblies [D]. Remove the lower cross tube [E]; then, remove the upper cross tube [F] as shown.
| [D] |
[A]
[B]
[C]
[F]
[E]
