Nortel Networks Attaching the BCM1000e to the rack, Installing the BCM1000e expansion unit

78Chapter 6 Installing the BCM1000e (expansion unit)

3Fasten the bracket to the BCM1000e using the four supplied screws.

Caution: Use only the screws that came with the bracket. Using other screws can damage the equipment.

4Repeat steps 2 and 3 on the other side, with the second bracket.

Note: Rack mount bracket

The BCM1000e rack mount bracket has an additional set of holes that allows you to install the brackets so that the unit sits flush with the BCM1000 in an equipment rack where space is limited.

Attaching the BCM1000e to the rack

The mounting brackets you attached to the BCM1000e correspond with mounting holes located on the equipment rack.

Note: You must supply your own screws to attach the BCM1000e to the rack.

1Determine the location in the rack you want to install the BCM1000e.

2Position the unit in the rack. Refer to Figure 33.

3Align the holes in the rack mounting bracket with the holes in the rails.

4Fasten the rack mounting brackets to the equipment rack using four screws.

Figure 33 Fasten the BCM1000e to the equipment rack

P0609324 01