Nortel Networks BCM1000 manual Entering the software keycodes

Chapter 9 Starting the system 129

6In the IP Address field, enter 10.10.10.2.

7In the Subnet Mask field, enter 255.255.255.0.

8Click OK.

9Click OK.

10Click Yes to restart the PC.

Connecting the Ethernet crossover cable

After you configure the computer, connect the computer to the BCM1000 in the following manner:

1Shut down the computer.

2Attach one end of the Ethernet crossover cable to the LAN card on the BCM1000.

3Connect the other end of the cable to the network interface card on your computer.

4Start the computer.

5Log on to the Unified Manager using the default IP address.

6Use the Quick Start Wizard to create the system configuration.

Refer to the Business Communications Manager Programming Operations Guide for details about using the wizard. The Programming Operations Guide provides a detailed record about the information that you require to configure basic system programming.

Warning: If you change this information on an existing system, the telephony programming is erased and the telephony system is disabled for a period of time. The Business Communications Manager also performs a cold start.

Entering the software keycodes

If you have purchased any of the optional Business Communications Manager applications that require keycode activation, refer to Business Communications Manager Software Keycode Installation Guide for information about how obtain the keycodes from the Nortel Networks Keycode Retrieval System (KRS) and how to enter them into the Unified Manager. These codes can be entered after basic system configuration is complete.

Regenerating keys after system replacement

If you need to replace your BCM1000, which would be the case if the motherboard or MSC became inoperable, you will need to regenerate all your keycodes to reflect the new system identification, and enter them again after you perform your system data restore.

Installation and Maintenance Guide