Nortel Networks BCM1000 Setting the DIP switches on the modules, Switches on the media bay module

90Chapter 7 Setting media bay module DIP switches

Setting the DIP switches on the modules

Before you install the media bay modules into the BCM1000 or BCM1000e housing, you need to set the DIP switches. Make a note of these settings either on the chart shown in Table 11 on page 88 or in the Programming Record forms.

Follow these steps to set the DIP switches:

1Locate the DIP switches on the module.

Figure 40 Switches on the media bay module

Underside of the
media bay module
6	5 4	3	2	1	Off
					On
							Module is
DIP switches				On	1	2 3 4 5 6	right-side up
Back of the media bay module
				Off
		Back of the media bay module

2Set the switches to correspond with the settings you chose “Determining module DIP switch settings” on page 87.

3Repeat for each media bay module you want to install.

GATM and ASM8+ modules: Set the country settings to either be off, if the country profile and software version for your system allows firmware downloads, or set the dip switches to activate the appropriate country settings. Refer to “GATM switch settings” on page 94.

4You are now ready to install the modules into the BCM1000 or BCM1000e units. Refer to Chapter 9, “Starting the system,” on page 115 for details.

P0609324 01