Nortel Networks BCM1000 manual Chapter Installing media bay modules

107

Chapter 8

Installing media bay modules

After you set the switches on the media bay modules, you can install them in the BCM1000 or the BCM1000e.

The BCM1000 accommodates a maximum of three media bay modules. If your system requires more than three media bay modules, you need to connect a BCM1000e to the BCM1000.

Figure 42 provides an overview of the process for installing media bay modules.

Note: The number of media bay modules you can add varies, depending on the DS30 resources that are available. Refer to Figure 27 on page 64.

Danger: The BCM1000 and BCM1000e must be correctly powered down before you install or remove media bay modules.

Figure 42 Process map: Installing a media bay module

Set module

DIP

switches

Disconnect cables from the front of the BCM1000 and BCM1000e

Disconnect power from both units

Remove front bezel from the BCM1000 or BCM1000e

Install new module

Replace coverplate

Restore power to

BCM1000 and

BCM1000e

Reconnect all cables
Monitor LEDs for
power and status.
		no
Is this	installation
part of a
	new
system	installation?		Use the	Unified
yes			Manager to identify the
			module to the system
Continue	with system
initialization

Installation and Maintenance Guide