Nortel Networks BCM1000 manual Quick start

188Chapter 16 Replacing the hard disk

Figure 94 Quick start page

12Enter the correct information for LAN1 (a), LAN2 (i), Subnet masks (m and j), Default next hop router (r) and System name (s), as required. Enter p after each change to apply it.

13Enter b (go back) to return to the System Configuration Start Page screen after all network IP addresses are configured.

14Enter r to reboot the system and to apply the network IP address changes

15Do one of the following:

•Run the Quick Start Wizard and manually reconfigure your system.

•Run the Quick Start Wizard to create the system parameters and defaults. Then restore your system data from your backup disk.

•Restore system and data information from your backup disk.

Warning: You can only perform a restore from a current backup disk that was backed up from the same software version as your system is currently running. If you do not have a current backup run on this version of software, you need to manually reenter your data.

16Test your system for correct operations.

P0609324 01