184Chapter 16 Replacing the hard disk

5The system automatically reboots as part of the initialization process. When the system reboots, the telnet session disconnects.

Note: If there is a modem, the system reboots four times. If there is no modem, the system only reboots twice.

6Do one of the following:

Run the Quick Start Wizard to create the system parameters and defaults. Then restore your system data from your backup disk.

Restore system and data information from your backup disk.

7Test your system for correct operations.

Initializing the hard disk (single-disk system BCM 3.0.1 and newer systems)

The BCM1000 is normally initialized at the factory. However, if you have to replace the hard drive in a single-disk BCM1000 running BCM version 3.0.1 (3.0 maintenance release) or newer releases, you must re-initialize the Business Communications Manager.

After you replace the hard disk and the system has booted up, perform the initialization as follows:

1Ensure the Status LED on the Business Communications Manager is lit. The Status LED indicates that all services have started and the Business Communications Manager is operating correctly.

2Attach a configuration computer to the base function tray serial port (recommended method). Continue to the next step in this procedure when complete.

Note: When you replace a hard disk, IP configuration data is lost. The Business

Communications Manager IP address defaults to: 10.10.10.1

You can access the Business Communications Manager through your local area network, using the IP address 10.10.10.1. However, if another network terminal uses this IP address, conflicts and network problems can arise.

3Access the Business Communications Manager from the configuration terminal using the terminal emulation program. Use the Business Communications Manager default IP address (10.10.10.1).

4Enter the terminal emulation program, as described in “Finding the configuration menus” on page 126. The Main Menu should display (Figure 89).

P0609324 01

Page 210
Image 210
Nortel Networks BCM1000 manual Replacing the hard disk