Nortel Networks BCM1000 manual ASM wiring chart, Pin Wire color Port Set

138 Chapter 10 Wiring the modules

Table 35 and Figure 58 provide the wiring scheme for the eight pairs that connect to an ASM.

3Plug the female amphenol connector into the interface on the front of the module.

Figure 58 Wiring for an ASM 8 or ASM8+

25-pair female	1T 2T		3T 4T	5T	6T	7T	8T
							33R
amphenol
	26R	28R 29R 30R31R 32R
connector		27R

WARNING: Ensure that you have Tip (T) and Ring (R) connected to the appropriate pins.

Table 35 ASM wiring chart

Pin	Wire color	Port	Set
26	White-Blue	X01	1
1	Blue-White	X01	1
27	White-Orange	X02	2
2	Orange-White	X02	2
28	White-Green	X03	3
3	Green-White	X03	3
29	White-Brown	X04	4
4	Brown-White	X04	4
30	White-Slate	X05	5
5	Slate-White	X05	5
31	Red-Blue	X06	6
6	Blue-Red	X06	6
32	Red-Orange	X07	7
7	Orange-Red	X07	7
33	Red-Green	X08	8
8	Green-Red	X08	8
34-50	no connection
9-25

Note: Refer to “Line and extension numbers for specific modules” on page 91 to see the relationship between the DS30 bus number and the DNs. Configuration information is included in the chapters on setting up modules and DNs in the Business Communications Manager Programming Operations Guide.

4Set up any mobile system you are using.

•Ensure the base stations are correctly installed and connected to the appropriate modules on the Business Communications Manager hardware. In the case of the NetVision wireless system, ensure that the access point is correctly set up to connect to the BCM1000 LAN or WAN.

•Configure and register the handsets according to the instructions provided for each type of system.

—Companion: Programming Operations Guide

—DECT: DECT Installation and Maintenance Guide

—T7406: T7406 Cordless Handset Installation Guide

P0609324 01