Nortel Networks BCM1000 manual Installing a media bay module, Removing the front bezel

Chapter 8 Installing media bay modules 109

Installing a media bay module

After the system is powered down, you can install and remove media bay modules, as required. Follow these procedures to install a media bay module. Reverse the procedure to remove modules.

1Ensure that the switches on the media bay module are set correctly. For information about how to set the switches, refer to Chapter 7, “Setting media bay module DIP switches,” on page 83.

In the case of FEM modules, the switches activate the front ports. Ensure that the switches accurately reflect the ports you require. Refer to “FEM switch settings” on page 106.

2Remove the front bezel from the unit where you want to install or remove the module by grasping the edges and pulling forward. Refer to Figure 43.

Figure 43 Removing the front bezel

BCM1000

Grasp the edge of the front bezel and pull it forward

BCM1000e

1.Push against the bottom

2.Pull out from the top

3Select an open media bay.

4Pull the latch beside the selected bay to release the media bay bezel. Refer to Figure 44.

Figure 44 Identifying the media bay module latches

BCM1000

media bay module latches

BCM1000e

Installation and Maintenance Guide