Nortel Networks manual BCM1000 LED states

118Chapter 9 Starting the system

Table 28	BCM1000 LED states (Continued)
LED				Red LED On
Label	Description	Green LED On	Green LED Flash	(Only)	Green LED Off
4	PCI Device	Device is present	driver is not running	N/A	Device is not
		and the driver is			present.
		active
5	PCI Device	Device is present	driver is not running	N/A	Device is not
		and the driver is			present.
		active
	Temperature	Temperature is	N/A	Temperature is	N/A
		below threshold.		in alarm status.
	Fans	All installed fans are	N/A	There is a	N/A
		working		problem with a
				fan.

1If the Power LED does not light: a Disconnect the power cords.

b Check all cables and power connections. Ensure that the ac outlet has power. c Reconnect the power cords.

Note: You can monitor the state of the BCM1000 LEDs from your computer. Refer to “Using the System Status Monitor to monitor LEDs” on page 162.

2When the system power is on, and the system has successfully booted, the power and status LEDs on the faceplates of the media bay modules are lit and remain constant. Refer to the media bay module sections in Chapter 2, “Telephony hardware,” on page 33 for a description of media bay module LED states.

3You are now ready to connect the hardware to the network.

P0609324 01