2 Wall Mounting Wood stud

2-1Locate studs

41 - 61 cm

(16 - 24 in.)

< 16 mm (5/8 in.)

2-2Mark the wall

[01]

2-3Drill pilot holes

2-4Tighten lag bolts

[01]

13 mm

5.5mm

(1/2 in.)

(7/32 in.)

For assistance in determining wall plate location, see Height Finder at sanus.com.

Verify the center of the stud(s) using an awl, a thin nail, or an edge to edge stud finder.

CAUTION: Avoid potential personal injuries and property damage!

ÙÙ Any material covering the wall must not exceed 16 mm (5/8 in.).

ÙÙ Minimum wood stud size: common 2 x 4 in (nominal 1.5 x 3.5 in).

Level the wall plate [01] and mark the hole locations.

CAUTION: Avoid potential injuries or property damage! Pilot holes MUST be drilled to a depth of 89 mm (3.5 in.), using a 5.5 mm (7/32 in.) diameter drill bit.

89mm (3.5 in.)

CAUTION: Avoid potential injuries or property damage! Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage:

ÙÙ DO NOT over-tighten the lag bolts [25].

ÙÙ Tighten the lag bolts [25] only until the washers [27] are pulled firmly against the wall plate [01].

[25]

8

[27]

6901-002114<01>

Page 8
Image 8
Sanus Systems LF228 Wall Mounting Wood stud, 1Locate studs, 2Mark the wall 3Drill pilot holes 4Tighten lag bolts, 13 mm