Unit Installation
Adjusting the Sensitivity of the Odor Sensor
1 q Press the Release buttons (both sides) at the bottom of the unit, w pull the front cover away from the unit, and
elift.
e
Front Cover
Release Button
Release Button
q 
w
q
2 Adjust the sensor sensitivity adjustment slide tab.
¡The tab is set to the middle when shipping.
Set the tab to this location during normal operation.
¡To operate when even slightly dirty set to “High”
¡To operate infrequently set to “Low”
Sensor Sensitivity
Adjustment Slide Tab
Unit Installation
1 Place the unit on a stable and horizontal surface and in a location where the air circulates well around the room.
¡This unit operates more effectively when the unit is set in the middle of a wall facing the center of the room.
Caution
¡Unplug the unit when moving or not using for extended periods and dispose of the water in the electrolyzed water unit and tank (water may spill or mold and bacteria may develop).
¡Do not tilt the unit when in use. The electrolyzed water unit may cease to operate properly or water may spill.
Note:
¡Do not set in a location where the air inlet or outlet may be covered.
¡Ensure that AV equipment, i.e. TV and radios, is located at least 6.5ft away (noise may interfere with the equipment).
Ventilate the room to clean the air before plugging the cord into the wall outlet.
2 ¡When the power plug is inserted into the wall outlet and the unit starts operating, the sensor will detect the cleanliness of the air and use this as a reference for making settings. The automatic operation lamp (green) will flash for a short while (about 3 minutes) while this is being done. If the air quality is detected as being clean, the settings will be updated automatically to reflect this.
