GB

Step : 1 Mains Connection

Connect the display unit to VGA, BNC and Scart connector as required.

AC connection

1.Connect the IEC power connector to the mains inlet at the rear of the LCD monitor as shown above.

2.Connect the power cord of the LCD monitor to a wall outlet.

As this product does not have a mains On/Off switch, please ensure your mains plug is easily accessible.

The LCD monitor is prepared for a mains voltage AC220~240V, 50Hz. To completely switch off the mains, or when the display unit is not to be used for an extended period of time, it is advisable to disconnect the power cord from the power outlet.

Please use the correct mains lead supplied with the set for your area

3. Warning: To prevent injury, the unit must be securely attached to the wall in accordance with the installation instructions.

WARNING! High voltages are used in the operation of this set. Refer service to qualified service personnel.

Step : 2 Connections

INPUT selection

To switch between AV1, RGB, AV2 (RGB H/V or Y, Pb, Pr) AV3, DVI or PC mode press the TV/ AV button on your remote control repeatedly or press and hold the TV/AV button for a few seconds and a selection menu will appear on screen.Use the e or d buttons to select the correct input.

1.AV1

SCART connection

2.RGB

TTL input (5V RGB signals) into SCART terminal

3.Y,Pb,Pr/ RGBHV connection (AV2)

This LCD monitor has a choice of Y, Pb, Pr or RGB H/V connections. You can connect your DVD player to the Y, Pb, Pr terminals instead of using a scart lead. This can support high definition in analogue component form. RGB H/V can be used as a PC input via the BNC terminals.Both options support a large range of resolutions (page 11).

4

GB

4.AV3

Composite (CVBS) signal input

AV3 OUT is to output the composite video signal from the VIDEO IN so that you can connect monitors with the use of a loop through function.

5.RS232C IN/OUT: Is a input for external commands to control the monitor (see page 8).

6.DVI-D (Digital Video Interface)

This monitor has an DVI connector. This is located at the back of the monitor next to the phono sockets. This input will support a large range of resolutions as shown on page 11. See page 6 for details of menu operation.

7 PC connection

This LCD monitor has a PC connector (PC-IN D-SUB).You can connect a PC to the LCD monitor and use it as a monitor display (see page 7). Audio can be connected via the 3.5mm PC audio in socket.This input will support a large range of resolutions (see pg11).

8. External Audio Output

To output the audio signal from AV 1,2,3, PC and DVI. The speaker impedance should be 8 ohms.

Use of Monitor Audio Output Connections

The audio monitor out sockets on the rear of the set provide a fixed level audio output for reproducing sound via your audio equipment.

Page 4
Image 4
Sanyo CE42SRE1 instruction manual Mains Connection, Use of Monitor Audio Output Connections