Sanyo CE52LH1R instruction manual Gbinstallation, Mains Connection, Connections, PJ-Net

GBINSTALLATION

GB

Step : 1 Mains Connection

■Connect the display unit to VGA, BNC and Scart connector as required.

PJ-Net

L	R
L	R
AV2-IN
	N5VW

1.Connect the in-line power connector to the connector attached to the LCD monitor as shown above.

2.Connect the power cord of the LCD monitor to a wall outlet.

✐As this product does not have a mains On/Off switch, please ensure your mains plug is easily accessible.

✐The LCD monitor is prepared for a mains voltage AC120V, 50Hz/

60Hz. To completely switch off the mains, or when the display unit is not to be used for an extended period of time, it is advis- able to disconnect the power cord from the power outlet.

✐Please use the correct mains lead supplied with the set for your

area.

3. Warning: To prevent injury, the unit must be securely attached to the wall in accordance with the installation instructions.

WARNING! High voltages are used in the operation of this set. Refer service to qualified service personnel.

Step : 2 Connections

■INPUT selection

To switch between AV1, AV2, AV3, PC or DVI press the INPUT button on your remote control repeatedly.

1.AV1

SCART connection

2.RGB

TTL input (5V RGB signals) into SCART terminal

3.Y,Pb,Pr/ RGBHV connection (AV2)

This LCD monitor has a choice of Y, Pb, Pr or RGB H/V connections. You can connect your DVD player to the Y, Pb, Pr terminals instead of using a scart lead. This can support high definition in analogue component form. RGB H/V can be used as a PC input via the BNC terminals.Both options support a large range of resolutions (page 14).

4. AV3

Composite (CVBS) signal input

AV3 OUT is to output the composite video signal from the VIDEO IN so that you can connect monitors with the use of a loop through function.

5.DVI-D (Digital Video Interface)

This monitor has a DVI connector. This is located at the back of the monitor next to the phono sockets. This input will support a large range of resolutions as shown on page 14. See page 7 for details of menu operation.

L	R
L	R
AV2-IN

6.PC connection

This LCD monitor has a PC connector (PC-IN D-SUB). You can connect a PC to the LCD monitor and use it as a monitor display (see page 9). This input will support a large range of resolutions (see page 14). Audio can be connected via the 3.5mm PC audio in socket.

7.PJ Net IN: Has the ability for PJ-NET to be connected to control the monitor using a network.

5