Sanyo CE52LH1R instruction manual Installation Mode

GB INSTALLATION MODE

GB

Installation Mode

Installation Mode

1.08

Temperature Error

This LCD monitor allows you to set up the following:

SETTING PROCEDURE

1 . Press and hold the GREEN button on the remote control for 4 seconds. (Installation Mode will appear)

2.Use the 5or 6button to highlight each option, use the 1￿or 2button to adjust each option. Press the MENU button to exit the mode.

■On Program

Select ON program using the 5or 6button, select the start up position using the 1￿or 2￿buttons.

(Off/ AV1/ AV2/ AV3/ PC/ DVI)

■Max Volume

Select Max volume using the 5or 6button, use the 1￿or

2￿buttons to set the maximum volume required.

■Winter mode

This Function can be activated when the LCD monitor is used during cold temperature conditions, approximately 38˚F/ 4˚C or below to maintain picture performance.

Using the 5or 6button select winter mode, once highlighted you can select ON or OFF by pressing the 1￿or 2 button. IMPORTANT: The AC cord should not be disconnected during the operation of Winter mode function.

When in winter mode, power consumption is higher than normal standby consumption. This is entirely due to the operation of heating circuitry. We strongly recommend to turn off Winter mode when the ambient temperature is above 38˚F/ 4˚C.

■RC inhibition

You can prevent unwanted remote control operation by selecting RC Inhibition.

Select using the 5or 6 button. Press the 1￿or 2 button to select On or Off.

To re-instate RC operation press and hold the green button on the remote control and select RC inhibition OFF.

■Child Lock

You can prevent unwanted operation of the LCD monitor via the buttons on the rear of the monitor.

Select using the 5or 6 button. Press the 1 button to select On or OFF.

■Address

Set the address for the LCD monitor.

■Baud rate

Select Baud rate using the 5or 6 button. To set the transmission speed for PJ-NET communication of 19200 or 9600 Baud rate by pressing the 1￿or 2 button.

■Panel Protect Rotation

Select Panel Protect Rotation using the 5or 6 button, once highlighted you can select ON or OFF by pressing the 1￿or 2 button.

■AV Auto shut off

Select AV Auto Shut Off using the 5or 6 button, once highlighted you can select On or Off by pressing the 1￿or 2 button.

■LED Light setting

Select LED Light setting usinig the 5or 6 button, once highlighted you can select On or Off by pressing the 1￿or 2 button.

■DCR

Select DCR usinig the 5or 6 button, once highlighted you can select On or Off by pressing the 1￿or 2 button.

■Main S/W Version

To record the version for Main Software.

■Temperature Error

This function can record times for abnormal temperature.

■IP Address / Subnet / Gateway / DNS

These 4 items display the PJ-Net information. If no PJ-NET had been connected, all the items would be displayed “000000000000”.

✐Disconnecting the mains supply before exiting Installation Mode will cancel the following features On program, RC inhibition, Address and Baud Rate.

10