INITIAL PROGRAMMING

Resetting to default

You can reset the phone programming to the initial factory default settings. The default settings are:

Language

English

Area Code

- - -

Ringer Tone

1

Tone/Pulse Setting

Tone

1.Make sure the phone is OFF (not in TALK mode).

2.Press FLASH/PROG repeatedly until “DEFAULT 1 NO” shows on screen.

3.Press CID or , or the 1 or 2 keys to select your choice between “1 NO” and “2 YES” for Default Settings”

4.Press FLASH/PROG again to confirm. You will hear a confirmation tone.

BASICS

Receiving a call

When receiving an incoming call, the LED on the handset flashes, and the handset will show caller information. *

*Note: A subscription is required from your local phone company to receive Caller ID information on your phone. See Caller ID Features, page 15.

1.Press TALK to answer the call.

Note: If handset is in the base cradle, remove it from base before pressing the TALK key. Either handset 1 or handset 2 can answer the call at once. (for CLT-A5822 and CLT-A5832)

2.Press TALK to end your call.

Note: If you replace the handset to the base cradle or charger cradle (for CLT-A5822 and CLT-A5832), the handset automatically hangs up.

11

sy5822 10 april.p65

11

2006/5/12, ¤U¤È 02:52

Page 11
Image 11
Sanyo CLT-A5832, CLT-A5822 instruction manual Basics, Resetting to default, Receiving a call