Sanyo DIR-2000 Using the Channel Map, Sub, ENTER, TUNER, CH MAP, CH MAP, CH MAP, CURSOR, selected, Need help, channels display, CHannel Map page(s), Figure 40

Using the Channel Map

1. Press the CH MAP key on the remote control once to display the			QuickTips

	CHannel Map page(s).		■ Pressing the CH Map
			■ Pressing the CH Map
2. Use the		/ keys to highlight the desired category: DTV	remote key will display
2. Use the		/ keys to highlight the desired category: DTV	a blank page with cat-
	or NTSC.		a blank page with cat-
3. Press the CH MAP key to exit.			egory tabs only, if
3. Press the CH MAP key to exit.			channel signals are
			channel signals are
NOTE: Deleted channels will be blue. The current channel will			not detected.
	have a yellow background.		■ When the CHannel
			■ When the CHannel
			Map page is active,
			only the Power, CH
		Figure 40—NTSC CH Map	Map, Tuner, Enter and
			Cursor keys are
			operational.
			■ When the CHannel
			Map page is active, the
			TUNER key will switch
			between the tuning
	Express Channel Selection		systems (DTV and
	Express Channel Selection		NTSC).

To quickly select a channel within the CHannel Map page:

1.Press the CH MAP key on the remote control.

2.Use the / keys to highlight the desired category: DTV or NTSC.

3.Use the CURSOR keys to highlight the desired channel. For example, Channel 52. Press the ENTER key. (See Figure 42.)

To quickly switch between a DTV and NTSC channel:

Figure 41—Channel Map of NTSC

1. Press the TUNER key repeatedly until the desired tuning systemchannels display channel number display appears on the screen.

2.Select an NTSC cable channel by entering the channel number. For cable channels above 100 press and hold the 1 key for about two seconds (until 1--appears). Then enter the other two digits.

3.Select a DTV channel by entering the major and minor numbers of the channel as follows: 4, 3, (–) Sub, 0, and 5 for channel “D43-05.”

NOTES:

•The CHannel Map shows all available channels and reflects the current status of channels within the CHannel Scan Memory. All deleted channels will appear blue.

•The tuner channel (DTV and NTSC) categories:

DTV (digital) channels with only major channel numbers listed.

NTSC (analog) channels with Cable channels 01~125 or VHF/UHF channels 02-69.

•Entering 00 for the minor channel number will cause the SDB to tune to the NTSC channel matching the major channel number.

Figure 42—NTSC Channel C52,selected

Need help?

Visit our Web site at