POSITIONING THE LCD HDTV

Always use a firm and flat surface when positioning your HDTV.

Do not position the unit in a confined area.

Allow adequate space for proper ventilation.

Do not position the HDTV where it is easily reachable by small children and may present risk of injury.

STAND REMOVAL AND WALL MOUNTING (OPTIONAL)

Tools Needed: Phillips screwdriver

IMPORTANT NOTE: Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish.

Wall mounting of the HDTV must be performed by a skilled person.

1Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw.

2Use the screws you removed when detaching the stand to secure the HDTV to a wall mounting kit (not included.)

VESA standard interface: 400 x 400

Mounting screws measurements:

M6 (6mm) Diameter, Length—12mm (maximum)

Need help?

GETTING STARTED

BATTERY INSTALLATION

Install two (2) “AAA” batteries in the remote control. (Not included)

To ensure safe operation, please observe the following precautions:

Replace both batteries at the same time. Do not use a new battery with a used battery.

There’s a risk of explosion if a battery is replaced by an incorrect type.

Do not expose the Remote Control unit to moisture or heat.

Be sure to match the “+” and signs on the batteries with marks inside the remote control.

ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE

Hook up your antenna or your cable service to the HDTV’s ANT terminal with the use of a 75 OHM coaxial cable.

NOTE: Keep your indoor antenna at least 3 ft. away from the television set and any other electronic equipment.

ANTENNA

ANALOG / DIGITAL

ANTENNA IN

CABLE

The tuner in this HDTV can receive:

Digital and Analog off air signals from an antenna

Analog or ClearQAM cable channels from a direct Cable TV connection.

www.sanyoctv.com 1-800-877-50325

Page 5
Image 5
Sanyo DP46840 Positioning the LCD Hdtv, Getting Started, Stand Removal and Wall Mounting Optional, Battery Installation