MagicSpin Installation Guide

Click ADD and select IDE CD-ROM and click install

Windows NT 4.0 Installation

Power on your PC.

Start the Windows NT

Once in the desktop, click on the Start button > Settings >

Control Panel > Devices

Select "ATAPI" from the list and click on the "Startup" button

When you get the startup screen, check "Boot" then click The "OK" button

Close the Devices screen and click on the Start button > Shut

Down and restart the computer

Note: If the setup program asks for floppies instead of prompting for the current driver, exit setup, and copy the ATAPI.SYS file from your NT setup Disk to directory \WINNT35\SYSTEM32\DRIVERS, then run the above setup procedure again.

DOS or Windows 3.1x Installation

Power on your PC and go to the Dos prompt.

If your PC boots into Windows 3.X automatically, you need to exit Windows to the Dos prompt.

Insert the driver diskette into a floppy drive.

Type A:\install (where A:\ is your floppy drive)

Follow the instructions on the screen.

Follow the instructions on the screen to complete the rest of the installation process.

Remove the Driver Diskette and Reboot your computer.

Once the installation is complete, remove the driver diskette and reboot your computer. This is necessary for your computer to detect your new CD-ROM.

Page 14

Page 14
Image 14
I/O Magic MagicSpin manual Windows NT 4.0 Installation, DOS or Windows 3.1x Installation