I/O Magic MagicSpin manual CD-ROM Troubleshooting, Use Registry Editor at your own risk

MagicSpin Installation Guide

Troubleshooting

CD-ROM Troubleshooting

The PC cannot detect the CD-ROM drive after installation. (Windows 98/95)

If you are connecting the CD-ROM drive to the motherboard, read this:

Make sure that there are no conflicts, both Primary and Secondary IDE controllers are present and without yellow exclamations on them. To check the status of your IDE controllers, click on the Start button > Settings > Control Panel > System > Device Manager (under the Hard Disk Controllers category). Yellow exclamation marks on the IDE controllers mean that the device is not working properly, not install properly or have a resource conflict with another device. Some retail version of Windows 98/95 may not recognize some of the IDE controllers. This can result in IDE devices (such as CD-ROM drives) not being detected or disappearing from the PC.

There are several ways to correct the problems.

1.If the Primary or Secondary IDE controllers are not present, read this:

Your controllers are not setup properly and you need to get a patch from your motherboard manufacture or check your BIOS setup and make sure that both onboard IDE controllers are enable. Visit our web site (www.iomagic.com) for additional help.

2.If the Primary and Secondary IDE controllers are present but they have yellow exclamation marks, read this:

The protected-mode driver for the hard disk controller was not properly initialized when you started Windows previously. When this occurs, a NOIDE entry is placed in the registry, preventing Windows from making future attempts to initialize the protected-mode driver. You might try to resolve the problem by editing your Registry.

WARNING: Using Registry Editor incorrectly can cause serious problems that may require you to reinstall Windows. I/OMagic cannot guarantee that problems resulting from the incorrect use of Registry Editor can be solved.

“Use Registry Editor at your own risk.”

NOTE: You should make a backup copy of the registry files (System.dat and User.dat) before you edit the registry.

Go to the Start button then Run and type REGEDIT. Then go to the following directories to remove the NOIDE if it is listed. Once removed reboot system.

HKEY_LOCAL_MACHINE\SYSTEM\CURRENTCONTROLSET\SERVICES\VX D\IOS

After you update the registry, restart Windows. Windows will then attempt to initialize the protected-mode driver for the controller. If no problems are encountered, the file system and virtual memory will operate in 32-bit mode, and Device Manager will not display an exclamation point in a yellow circle for the IDE channels. If the protected-mode driver is not initialized properly, an error message

Page 18