Search Mode Operations
5. MOTION DETECTION SEARCH
If a motion sensor has been set to detect movement in a particular camera view, and images for that view have been saved in the normal recording area or alarm recording area, you can search for those images that have changed as a result of movement by an intruder, for example, and play back those images.
1
2
3
4
5
6
Select [MOTION DETECTION SEARCH] from the [SEARCH] menu.
The MOTION DETECTION SEARCH screen will be displayed.
Select the recording area to search for images from the [SEARCH FROM] menu.
•ALARM: Only alarm recording area images will be searched.
•NORMAL: Only normal recording area images will be searched.
•ALARM AND NORMAL: Images in both the alarm recording area and the normal recording area will be searched.
Select the channel (camera number) to search for images from the [MULTIPLEXER CHANNEL] menu.
If the multiplexer function has not been used and only one channel is available,
Click the [SET] button. The recording start and recording end times for the images to be searched will be displayed in the [START] and [END] menus respectively. To refine the range over which to search, use the menu to adjust the [START] or [END] settings, and then click the [SET] button to apply the changes.
The search results will be displayed in a message box.
Specify the motion sensor search conditions.
• Sensor position
The MOTION SENSOR SET screen will be displayed, and it will be divided up into an 8 (H) × 10 (W) grid. Click the position where you wish to set the focus for the motion sensor. A red sensor setting mark will appear at that position. (If you click a sensor position again, the sensor setting will be canceled.)
•Sensor level
Select from the menu. The lower the number, the higher is the sensitivity.
Click the [PREVIEW] button to confirm the image in the PREVIEW screen.
Images in the specified time range in which the sensor has detected movement will be searched and displayed on the PREVIEW screen.
1
2
3
4
5
6
7
8
1SEARCH FROM
This selects the recording areas to search in.
2MULTIPLEXER CHANNEL
Channel (camera number) for images to be searched
3START/END
This selects the recording start and end times for the images to be searched.
4SET
This sets the search conditions.
5MESSAGE BOX
This shows the search results for images that satisfy the search conditions.
•SEARCHING: Searching for images.
•FOUND: Images satisfying the search conditions have been found.
•IMAGES NOT FOUND: No images that satisfy the search conditions were found.
6MOTION SENSOR SET Motion sensor setting screen
7MOTION SENSOR LEVEL Sets the sensor sensitivity. (OFF, 1 to 10)
8PREVIEW
Search image preview display.
7 After confirming that the image found is the one you wish to play back, click the PREVIEW screen.
The images starting from the point that the alarm occurred will be played back in a
English | 29 |
