Sanyo DSR-3716 manual 64

General settings

AData display settings/VIDEO LOSS settings

These settings are used to control the operating display area	3 Turn the J-dial, select "VIDEO LOSS", and turn the
of the monitor, to display the date, time and other	S-dial clockwise.
information. Normally all indicators are displayed, but they	The "ON" field starts blinking.
can be hidden, if needed.	Normally this is set to display. If necessary, turn the J-dial
"VIDEO LOSS" can be set to be displayed when a camera
	and hide it by setting it to "OFF".

video is interrupted due to an unexpected problem, or a lamp
connected to the rear panel control terminals can be turned on.					<DISPLAY SET>
Display the <DISPLAY SET> screen as explained in					DATE	: ON
					TIME	: ON
1 "Displaying the general settings screen", and then turn					QUALITY	: ON
			(J)	(S)	AUDIO	: ON
the S-dial clockwise. (P62)
					ALARM COUNT	: ON
The "ON" indicator on the DATE line starts blinking.					ALARM TYPE	: ON
					TITLE	: ON
MENU	<MAIN MENU>				VIDEO LOSS	: ON
	3.GENERAL SET
	<GENERAL SET>		4 Turn the S-dial clockwise.
	1.DISPLAY SET
(J)	(S)		5 Press the EXIT/OSD button.
	<DISPLAY SET>		EXIT/OSD
	DATE	: ON
	TIME	: ON
	QUALITY	: ON
	AUDIO	: ON
	ALARM COUNT	: ON
	ALARM TYPE	: ON	☞ Cancelling the VIDEO LOSS detection
	TITLE	: ON

• Connect a normal video signal.

VIDEO LOSS : ON

2Turn the J-dial, set the DATE to "OFF", and then turn the S-dial clockwise.

Repeat the same procedure for each item you want to hide from the display.

•If video signal connection is not necessary, then press the camera selection button where the VIDEO LOSS was detected, and then press the same camera selection button again for about 3 seconds.

English

		1 2	3 46 5
1	<DISPLAY SET>	01-01-06 00:00:00	REC REPEAT EN A ALARM 0000
	DATE	: ON
32	TIME	: ON
	QUALITY	: ON
34	AUDIO	: ON
	ALARM COUNT	: ON
76	ALARM TYPE	: ON
	TITLE	: ON
	VIDEO LOSS	: ON
			02
			7

☞The operating display area after setting the items "OFF".

01-01-06 00:00:00 REC REPEAT EN A ALARM 0000

63 How to set