![](/images/new-backgrounds/1230086/23008629x1.webp)
System Setup
2.3DOLBY DIGITAL SETUP 2.3.1 DUAL MONO
STEREO: The player outputs the
R- MONO: The player outputs the
MIX- MONO: The player outputs the average signal of the
NOTE: This function only applies to the Dolby AC
2. 3.2 DYNAMIC
When you watch films with large dynamic scope in low volume, for example at night, you can adjust the dynamic value up to avoid losing sound details resulting from the low volume.
2.4 CHANNEL DELAY
This item is used to set the delay time for the center, rear speakers and the subwoofer. The delay is to compensate for the audio propagation time difference caused by the distance difference of the speakers to the listener.
Use the direction key [ ]/[
] to select a speaker, center speaker, subwoofer, left surround
speaker or right surround speaker. Then use the direction key []/[
] to set the distance difference.
0cm
Sub woofer
NOTE:
The unit does not support delays for when the distance between the center or surround speakers and the listener are longer than that between the front speakers and the listener. In case the channel delay settings cannot match your speaker configuration, please set all distance difference to 0cm.
2.5EQUALIZER 2.5.1 SOUND MODE
Select a sound mode in this item.
2.5.2 BASS BOOST
Set it to ON to boost the bass sound.
2.5.3 SUPER BASS
Set it to ON to get the super bass sound effect.
2.5.4 TREBLE BOOST
Set it to ON to boost the treble sound.