FM Antenna Connection
CAUTION:
When installing an outdoor antenna, follow the installation instructions in the attached “IMPORTANT SAFETY INSTRUCTIONS”.
FM outdoor antenna (not supplied)
Ground
Antenna discharge unit (not supplied)
FM indoor antenna lead wire
Main unit (Left side)
The FM indoor antenna lead wire is sufficient to receive most local FM broadcasts and should be connected to the rear FM 75Ω terminal. Extend the antenna lead wire as straight as possible and, while listening to the sound from the system, secure it in a position where the best FM reception is found.
In fringe areas, or where reception is distorted or noisy, an FM outdoor antenna (not supplied) should be connected instead of the FM indoor antenna lead wire. The terminals will accept 75- ohm coaxial cable.
Note:
To minimize noise...
•Do not place the antenna close to a TV or speaker.
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s attention to Section
Additional Connection Examples
To enjoy your TV sounds
TV
If your TV has the audio output jacks, connect an audio cable (not supplied) from the audio output jacks of the TV to the AUX jacks.
Audio cable (not supplied)
Headphones jack (PHONES)
Connect a pair of stereo headphones with miniplug (8 ohms - 32 ohms, not available from SANYO) to the PHONES jack for monitoring or for private listening. The speakers are automatically disconnected when headphones are connected.
COMPONENT
VIDEO OUT
SELECT
PHONES jack
PHONES
Main unit (Right side)
Power Supply
Connect the power cord to a 120VAC 60Hz outlet.
The
Notes:
•Before plugging the power cord into an AC outlet, make sure that all the connections have been made.
•The
AC outlet.