ELECTRONIC CONTROL RESET

Press the SEL button ➁ for about 3 seconds until the unit beeps, the audio controls, except for vol5 ume, will be reset.

BASSXPANDER (BASX) - 1/2 . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

BASSXPANDER is a dual-mode sound equalization feature. Press button ➃ to select the BASSXPANDER modes as follows;

b-1 b-2 OFF

BASSXPANDER offers two preset modes: b-1 enhances the low and high frequencies, while b-2 enhances the low frequencies and reduces the high frequencies.

RADIO SELECTION BUTTON (BAND) . . . . . . . . . . . . . . . . . . . . 5

Press the BAND button ➄ to switch from tape, CD player or CD changer mode to radio. Each time the button is pressed, the function changes as shown below.

FMI FMII AM

TAPE SELECTION BUTTON ( ) . . . . . . . . . . . . . . . . . . . . . . 7

Press button ➆ to switch from radio, CD player or CD changer mode to tape mode.

CD PLAYER OR CD CHANGER* SELECTION BUTTON (CD/CD-CH) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Press the CD/CD-CH button ➅ to switch from radio or tape mode to CD player or CD changer* mode. * If a CD changer is connected.

Pressing the button will change the mode as follows:

1 When a CD is loaded in the CD player and a CD changer is not connected;

Radio/Tape CD player CD player pause

2 When a CD is not loaded in the CD player and a CD changer is connected;

Radio/Tape CD changer CD changer pause

3When a CD is loaded in the CD player and a CD changer is connected;

Radio/Tape CD player CD changer

CLOCK BUTTON (DISP) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

Press the DISP button ➇ to switch between the clock and audio display. When an audio function is performed while the time display is selected, the audio display will appear for 5 seconds, then the display will return to the timemode.

TO CANCEL THE BEEP TONES . . . . . . . . . . . . . . . . . . . . . . . . . 7

1 Tocancel all beep tones, press button ➆for more than 3 seconds with no tape in the slot, and then is displayed.

2To turn on the beep tones again, perform the same procedure. The beep tones are set and is dis5 played.

-+8+-