Sanyo KS2462R Operation with the Remote Control Unit continued, A.Automatic Cooling and DRY mode

Operation with the Remote Control Unit (continued)

NOTE

2.Adjusting the Fan Speed

A.Automatic

Cooling and DRY mode:

NOTE

B. Manual

•This appliance has a built-in three minutes time delay circuit to ensure reliable operation. When the operation button is pressed, the compressor will start running within three minutes. In the event of power failure, the unit will stop. When the power is restored, the unit will restart automatically after five minutes.

Simply set the FAN SPEED selector button to the position.

A microcomputer in the air conditioner automatically controls the fan speed

when the mode is selected. When the air conditioner starts operating, the difference between the room temperature and the set temperature is detected by the microcomputer which then automatically switches the fan speed to the most suitable level.

When difference between
room temperature and set	FAN SPEED
temperature is
4 °F and over	High
Between 4 °F and 2 °F	Medium
Below 2 °F	Low

The above mentioned data make reference to the conditioner operating when the sensor on the remote control unit is ON. (Refer to temperature sensor selector). If the sensor on the indoor unit is being used then actual operation will slightly differ from that described in the above tables. ( Sign shown on the remote control unit display.)

If you want to adjust fan speed manually during operation, just set the FAN

SPEED selector button as desired. [ , , or ]

OI-508-13EG 13