4

DISCONNECT THE LENS SHIFT CONNECTORS. (See figure-4)

Disconnect the Lens Shift Connectors ("K96S" and "K96R") from circuit board.

5

LEAD

HOLDER

CONNECTOR CONNECTOR

"K96S""K96R"

INSTALL THE LENS. (See figure-5)

Fig-4

1.Remove protective caps(front and back) on the lens.

2.Mount the lens on mounting bracket of the main cabinet with 4 screws.

Use the screws included with the lens. Use the driver included with the lens to fasten the screws.

(After using, keep it for latter use.)

ATTACHED DRIVER

6 INSTALL THE LIGHT-BLOCK SHEET. (See figure-6)

Install the light-block sheet around the lens as shown in the illustration. Use the sheet included with the lens.

Make sure the part no. and mark (TOP and BACK) on Light-Block Sheet and set them properly.

ADJUST FOCUS

Adjust focus following Focus Adjustment on page 6.

LENS MOUNTING BRACKET

Fig-5

LIGHT-BLOCK SHEET

Type FB1

(Part No. 610 285 8211)

Fig-6

-5-

Page 6
Image 6
Sanyo LNS-W03 manual Fig-6