Sanyo MDF-U333 instruction manual Optional Components, Model MDF-U537D

OPTIONAL COMPONENTS

Model MDF-U537D:

< Attachment of MTR-G85 on the left lower front of the freezer >

1.Attach the recorder to the mounting kit by following the procedure shown in the manual enclosed with the

mounting kit.

2. Remove the screw on the cover for the recorder space on the lower front of the freezer. Open the cover and push the shaft on the both sides outward to remove the cover. Fig. 14

3.Install the recorder in the recorder space.

4.Join the wire in the unit compartment with the

recorder wire by each wire connector. See Fig. 15

4. Remove the wire grille on the back bottom of the freezer. See Fig. 16

5. Route the capillary tube of the recorder to the back of the freezer through the unit compartment

6.Remove 2 rubber caps (outside and inside) on the access port on the back of the freezer and also remove the insulation in the port.

7.Pass the recorder sensor into the chamber through the access port. Fig. 17

8. After covering the recorder sensor with the cover provided, fix the recorder sensor under the middle shelf by using 2 enclosed binders. See Fig. 18.

9. Make a small cut on the rubber caps for capillary to pass.

10.Replace the insulation into the access port and cover the port completely with the rubber caps.

Access port

Fig. 17

17

Shaft

Fig. 14

Fig. 15

Fig. 16

Sensor

Fig. 18