Sanyo PDG-DHT8000L owner manual Terminals and Connectors

Part Names and Functions

Terminals and Connectors

q w e r t y

u

i o !0 !1

qUSB CONNECTOR (Series B)

USB connector is used to service the projector.

w5 BNC INPUT JACKS

Connect the component or composite video output signal from video equipment to VIDEO/Y, Pb/Cb, and Pr/Cr jacks or connect the computer output signal (5 BNC Type [Green, Blue, Red, Horiz. Sync, and Vert. Sync.]) to G, B, R, H/V, and V jacks. (pp.20–21)

eD-sub 15-PIN INPUT TERMINAL

Connect computer output (Analog D-sub 15-pin type) to this terminal. (pp.20-21)

rMONITOR OUT TERMINAL

This terminal can be used to output the incoming analog RGB, component, or composite video out signals from INPUT 1-2 terminal to the other monitor. (pp.20-21)

tDVI INPUT TERMINAL

Connect computer output (Digital/DVI-D type) to this terminal. (p.20)

HDTV (HDCP Compatible) signal can be also connected. (p.21)

yHDMI

Connect the HDMI output signal from video equipment to this terminal. (p.21)

uS-VIDEO INPUT JACK

Connect the S-VIDEO output signal from video equipment to this jack. (p.21)

iSERIAL PORT IN TERMINAL

If you control the projector through RS-232C from a computer, you must connect a cable (not supplied) from your computer to this terminal.

oSERIAL PORT OUT TERMINAL

This terminal outputs signal from SERIAL PORT IN. More than two projectors can be controlled through RS-232C from one computer by connecting SERIAL PORT IN of another projector to this terminal.

!0LAN port

Connecting the Ethernet cable. See the owner's manual of “Network Set-up and Operation” for details.

!1R/C JACK

When using the wired remote control, connect the wired remote control to this jack with a remote control cable (not supplied).

11