Appendix
The power is turned off | – Power management function runs by initial setting. Check “SETTING” section on page | |
automatically. | 57. | |
|
| |
You cannot operate with | – The side control is not available If the side control is locked at “Key lock” under | |
the side control. | “Security” of SETTING section. Please check “SETTING” section on page 58. | |
|
| |
| – Check the batteries. | |
| – Check if the RC sensor is set properly. (See page 56) | |
| – Make sure no obstruction is between the projector and remote control. | |
| – Make sure you are not too far from the projector when using the remote control. | |
The Remote Control does | Maximum operating range is 16.4’ (5m). | |
– Make sure that the remote control code conforms to the projector’s code. | ||
not work. | (See “SETTING” section on page 56.) | |
| – Make sure the reset switch in the compartment lid on back of the remote control is set | |
| to use position. | |
| – Unlock the Key lock function for the remote control. (See page 58) | |
| – Wireless remote control does not work when the remote control cable is connected to | |
| the projector. (See page 15) | |
Indicators blinks or lights. | – Check the status of the projector with referring to “ INDICATORS AND PROJECTOR | |
| CONDITION” on pages | |
|
| |
| – Your operation is invalid. Operate correctly. | |
appears on the screen |
| |
|
| |
Unable to unlock the Logo |
| |
PIN code lock, Security | – Contact the dealer where you purchased the projector or the service center. | |
key lock or Security PIN | ||
| ||
code lock. |
| |
|
| |
Forget the Logo PIN code | – Contact the dealer where you purchased the projector or the service center. | |
or Security PIN code. | ||
| ||
|
|
WARNING:
High voltages are used to operate this projector.. Do not attempt to open the cabinet..
If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the service center. Specify the model number and explain about the problem. We will advise you how to obtain service.
This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty, and electrical hazards.
The CE Mark is a Directive conformity mark of the European Community (EC).
Pixelworks ICs used.
75
