Sanyo PDG-DXL2000 Setting Smtp server and administrator address, Setting Smtp authentication

26

Chapter 3 Basic Setting and Operation

1Setting SMTP server and administrator address

Enter the server name or IP address of the SMTP server*1, the port number of the SMTP server and administrator address and click Set button. The administrator address is set to "Reply-To" address of the message sent from the projector.

*1 The SMTP server is a server for sending e-mail. Please contact your network administrator to have this SMTP server address.

2Registering and deleting E-mail addresses

Enter the e-mail address onto "Add e-mail address" and click Set button.

To check the registered addresses, click

Check/Delete sub menu tab. The address- es are listed as the figure on the right.

✐Up to 10 E-mail addresses can be registered.

To delete the registered addresses, check the address you want to delete and click Delete button.

3Setting SMTP authentication

Set the SMTP authentication concerned and click Set button. Please contact your network administrator in details.

✐ If the projector sends an alert message due to the abnormality on the projector but the SMTP server is down in some other reason, the message will not be sent. In this case, the message "Unable to connect to server." will be displayed on the setting page. To clear this message, set up SMTP server address again.

✐ To use the E-Mail function, it must be set the DNS address on the Network setting page correctly.

✐ You cannot use this E-mail function if the DNS server and SMTP server cannot be used in your net- work environment.

✐ The projector does not send message to the address set in "Administrator address" text box. If you want to send e-mails to the administrator address, enter the administrator address into "Add address" text box.