PREPARATION

SETTING-UP PLASMA MONITORCONNECTING AC POWER CORD

This Plasma Monitor uses nominal input voltages of 100- 120 V or 200-240 V AC. The Plasma Monitor automatically selects the correct input voltage. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of electrical shock, do not plug into any other type of power system.

Consult your authorized dealer or service station if you are not sure of the type of power supply being in use. Connect Plasma Monitor with the peripheral equipment before turning Plasma Monitor on. (Refer to pages 13 ~ 15 for connection.)

CAUTION

For safety, unplug the AC Power Cord when the appliance is not used.

Table Top Stand

(Option)

Connect AC Power Cord (supplied) to Plasma Monitor. The AC outlet must be near this equipment and must be easily accessible.

NOTE ON THE POWER CORD

The AC Power Cord must meet the requirement of the country where you use the Plasma Monitor. Confirm the AC plug type with the chart below and the proper AC Power Cord must be used.

If the supplied AC Power Cord does not match the AC outlet, contact your sales dealer.

Plasma Monitor sideAC Outlet side

 

For the U.S.A. and Canada

For Continental Europe

For the U.K.

Ground

 

 

 

 

 

 

 

 

To the AC Outlet.

 

 

To the AC Outlet.

 

 

 

 

 

 

 

(220 - 240 V AC)

To the POWER CORD CON-

 

(120 V AC)

 

To the AC Outlet.

 

NECTOR on Plasma Monitor

 

 

 

(220 - 240 V AC)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ATTACHING THE FERRITE CORES

Ferrite cores (supplied)

When you connect The Plasma Monitor to AC outlet, attach the supplied ferrite cores. Set the ferrite cores on the both ends of the AC power cord . Close the lid tightly until the clamps click.

9