PREPARATION

SETTING-UP PLASMA MONITOR

CONNECTING AC POWER CORD

This Plasma Monitor uses nominal input voltages of 100- 120 V AC. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of electrical shock, do not plug into any other type of power system.

Consult your authorized dealer or service station if you are not sure of the type of power supply being in use. Connect the Plasma Monitor to the peripheral equipment before turning on the Plasma Monitor. (Refer to P13 ~ 15 for connection.)

CAUTION

For safety, unplug the AC Power Cord when the appliance is not used.

Connect the AC Power Cord (supplied) to the Plasma Monitor. The AC outlet must be near this equipment and easily accessible.

NOTE ON THE POWER CORD

The AC Power Cord must meet the requirement of the country where you use the Plasma Monitor. Confirm the AC plug type with the chart below and the proper AC Power Cord must be used.

If the supplied AC Power Cord does not match the AC outlet, contact your sales dealer.

Plasma Monitor side

AC Outlet side

To the POWER CORD CONNECTOR

 

on Plasma Monitor

Ground

To the AC Outlet.

(120 V AC)

8