Setting
Standby mode
This function is available when operating the projector via network.
Network..... Supply the power to the network function even
after turning off the projector. You can turn on/ off the projector via network, modify network environment, and receive an
Eco............. Select Eco when you do not use the projector
via network. The projector’s network function will stop when turning off the projector.
Refer to the owner’s manual of “Network
Note:
•Factory default is Eco.
•When selecting Network, the cooling fans may be running depending on the temperature inside the projector even if the projector is turned off.
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.
Select one of the following options:
Ready | When the lamp has been fully cooled |
| down, the POWER indicator changes |
| to green blinking. In this condition, the |
| projection lamp will be turned on if the |
| input signal is reconnected or any button |
| on the top control or remote control is |
Shut down | pressed. |
When the lamp has been fully cooled | |
Off | down, the power will be turned off. |
Power management function is off. | |
Timer | If the input signal is interrupted and |
| no button is pressed for more than |
| 30 seconds, the timer display with No |
| signal appears. It starts the countdown |
| until the lamp is turned off. Use the Point |
| ▲▼ buttons to set the Timer(1~30min). |
Note:
Factory default is Ready: 5 min.
Power management
Timer left before Lamp is off.
52
