Setting

Picture in Picture

This function is used to project two videos simultaneously by placing a separate small sub screen within the main screen. (Picture in Picture combinations provided in this projector are shown on pages 75.)

Only the sound on the main picture is heard, the sound on the sub picture cannot be heard.( In P in P, the big picture is main picture, and the small one is sub picture; in P by P, the left picture is main picture, and the right one is sub picture.)

Picture in Picture

 

 

 

Picture in Picture

 

more...

Standby mode

Network

Mode. . . . . P in P :

P by P:

Off :

Subpicture size. . .

The sub picture in the main picture. The sub picture by the main picture. Exit the Picture in Picture menu.

Select the subpicture display size. Subpicture can be changed between Large, Small and Middle.

Subpicture position. . Set a position for subpicture. This function is used to set Subpicture position as follows:

the top left→ the bottom left → the bottom right→ the top right→• • •

Selecting the Main picture or Sub picture

During Picture in Picture mode, and no operation on the On Screen Menu, press the SELECT button to select main or sub picture. (When the sub picture is selected, a red frame will be displayed.)

Switching of the Input Source

In the main picture or the sub picture mode, choose input soure by pressing the INPUT button on the top control or pressing the COMPUTER 1/2, HDMI, VIDEO, S-VIDEO or COMPONENT button on the remote control or through Input Menu operation.

Operation of the Sub picture

In Picture in Picture mode, press the SELECT button to select the sub picture (the frame becomes red), and then

use the Point ▲▼◄► buttons to change Subpicture size,

switch the Main picture and the Sub picture, and move Subpicture position.

In Picture in Picture mode, press the Point ▲ button to switch the Main picture and the Sub picture.

In P in P, press the Point ▼ button to change Subpicture size.

In P in P, press the Point ◄► buttons to move

Subpicture position.

Note:

When the input signal(s) is/are incompatible, X mark will be displayed on the Main/Sub picture.

When the sub picture is set to the same signal as the main picture, X mark will be displayed.

Subpicture position and Subpicture size are only used for P in P.

Subpicture size

Note:

When P in P or P by P is set, Total dots is disabled in the PC adjust menu.

In Picture in Picture mode, the Freeze function is disabled.

During Picture in Picture mode and the Menu screen is displayed, below functions via the remote control operation are disabled.

Change Subpicture size.

Move Subpicture position.

Switching of the Main picture and Sub picture.

Select the Sub picture mode by the SELECT button.

51

Page 51
Image 51
Sanyo PLC-WXU300K Picture in Picture, Mode. . . . . P in P By P Off Subpicture size, Switching of the Input Source