Pioneer VSA-AX10Ai Using other functions Dimming the display, Switching the speaker impedance

08Using other functions

Dimming the display

You can choose between four brightness for the front panel display. Note that when selecting sources, the display automatically brightens for a few seconds.

•From the remote control amplifier menu, press DISPLAY DIMMER repeatedly to change the brightness of the front panel display.

You may need to press AMPLIFIER on the Home menu () first before reaching the amplifier menu screen shown

below (use the (cursor left/right) soft keys to go to the previous/next menu screen).

AMPLIFIER 3/3

TV

RECEIVER CONT

SB CH

INPUT MODE

SPEAKER	INPUT
A/B	ATT

VIDEO DISPLAY

SELECT DIMMER

TAPE2 STATUS

MONITOR

Switching the speaker impedance

• Default setting: Speaker 6Ω

You can use speakers with a nominal impedance between 4–16Ωbut if you are using speakers with an impedance of less than 6Ω, you must change the impedance setting below.

• With the amplifier in standby, press		STANDBY/
ON while holding down the OPTION – button.
STANDBY/ON
	STANDBY
	VIDEO	AUDIO
OFF ON		CD-R/
	DVD/LD TV/DVD SAT VIDEO DVR/VCR1 VCR2 VCR3 CD	TAPE1/MD TUNER P

INPUT SELECTOR

ACOUSTIC										CHLEVEL	SBCH
CAL.	MIDNIGHT	LOUDNESS	TONE	OPTION			DIGITALNR	INPUTATT	SELECT		MODE
PHONES	SPSYSTEM	SIGNAL	VIDEO	TAPE2	STREAM	SETUP			VIDEOINPUT
	A/B	SELECT	SELECT	MONITOR	DIRECT	MIC	DIGITALIN
									S-VIDEO	VIDEO	L AUDIO R

Each time you do this, you switch between the impedance settings:

•Speaker 4Ω – Use this setting if your speakers are rated lower than 6Ω (down to 4Ω).

•Speaker 6Ω – Use this setting if your speakers are rated 6Ω–16Ω.

Note

•If you select Speaker 4Ω above, the Stream Direct setting is fixed at SD:1 NORMAL (see Using the Stream Direct mode on page 43).

72

En