Pioneer VSA-AX10Ai manual Operating Environment, Risk of Electric Shock Do not Open

D3-4-2-1-3_En

D3-4-2-1-7c_En

D3-4-2-1-9a_En

D3-4-2-1-4_En

D3-4-2-1-7b_En

IMPORTANT

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

CAUTION:

TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

D3-4-2-1-1_En

Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel.

IMPORTANT		The cut-off plug should be disposed of and must	Do not connect either wire to the earth terminal of a
		not be inserted into any 13 amp socket as this can	three pin plug.
		result in electric shock. The plug or adaptor or the	NOTE
FOR USE IN THE UNITED		distribution panel should be provided with 10 A
		fuse. As the colours of the wires in the mains lead	After replacing or changing a fuse, the fuse cover in
KINGDOM
		of this appliance may not correspond with coloured	the plug must be replaced with a fuse cover which
The wires in this mains lead are coloured in		markings identifying the terminals in your plug,	corresponds to the colour of the insert in the base
accordance with the following code:		proceed as follows ;	of the plug or the word that is embossed on the
Blue	: Neutral	The wire which is coloured blue must be connected	base of the plug, and the appliance must not be
Brown	: Live	to the terminal which is marked with the letter N or	used without a fuse cover. If lost replacement fuse
If the plug provided is unsuitable for your socket		coloured black.	covers can be obtained from your dealer.
outlets, the plug must be cut off and a suitable plug		The wire which is coloured brown must be	Only 10 A fuses approved by B.S.I or A.S.T.A to
fitted.		connected to the terminal which is marked with the	B.S.1362 should be used.
		letter L or coloured red.	D3-4-2-1-2-2_En

Thank you for buying this pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference.

WARNING:

BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY. The voltage of the available power supply differs according to country or region. Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e.g., 230V or 120V) written on the rear panel.

WARNING: No naked flame sources, such as lighted candle, should be placed on the apparatus. If naked flame sources accidentally fall down, fire spread over the apparatus then may cause fire.

D3-4-2-1-7a_En

This product complies with the Low Voltage Directive (73/23/EEC, amended by 93/68/EEC), EMC Directives (89/336/EEC, amended by 92/31/EEC and 93/68/EEC).

WARNING: The apparatus is not waterproofs, to prevent fire or shocks hazard, do not expose this apparatus to rain or moisture and do not put any water source near this apparatus, such as vase, flower pot, cosmetics container and medicine bottle etc.

VENTILATION: When installing this unit, make sure to leave space around the unit for ventilation to improve heat radiation (at least 60 cm at top, 10 cm at rear, and 30 cm at each side).

WARNING: Slot and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating, to prevent fire hazard, the openings should never be blocked and covered with items, such as newspapers, table-cloths, curtains, etc. Also do not put the apparatus on the thick carpet, bed, sofa, or fabric having a thick pile.

Operating Environment

Operating environment temperature and humidity: +5 ºC – +35 ºC (+41 ºF – +95 ºF); less than 85 %RH (cooling vents not blocked)

Do not install in the following locations

•Location exposed to direct sunlight or strong artificial light

•Location exposed to high humidity, or poorly

ventilated location