Pioneer VSA-AX10Ai manual Adjusting the delay of a soundtrack

08Using other functions

Reducing the level of an analog signal

The input attenuator lowers the input level of an analog signal when it’s too strong. You can use this if you find the that the OVER indicator is lights often, or you can hear distortion in the sound.

•From the remote control amplifier menu, press INPUT ATT to switch the input attenuator on or off.

You may need to press AMPLIFIER on the Home menu () first before reaching the amplifier menu screen shown

below (use the (cursor left/right) soft keys to go to the previous/next menu screen).

AMPLIFIER 3/3

TV

AMPLIFIER CONT

SB CH

INPUT MODE

SPEAKER	INPUT
A/B	ATT

VIDEO DISPLAY

SELECT DIMMER

TAPE2 STATUS

MONITOR

ACOUSTIC										CHLEVEL	SBCH
CAL.	MIDNIGHT	LOUDNESS	TONE	OPTION			DIGITALNR	INPUTATT	SELECT		MODE
PHONES	SPSYSTEM	SIGNAL	VIDEO	TAPE2	STREAM	SETUP			VIDEOINPUT
	A/B	SELECT	SELECT	MONITOR	DIRECT	MIC	DIGITALIN
									S-VIDEO	VIDEO	L AUDIO R

Note

•The attenuator isn’t available with digital sources, or when using Stream Direct modes 2 or 3.

70

Adjusting the delay of a soundtrack

Some monitors have a slight delay when showing video, so the soundtrack will be slightly out of sync with the picture. By adding a bit of delay, you can adjust the sound to match the presentation of the video.

1Press OPTION repeatedly until SOUND DELAY shows in the display.

With the remote, you may need to press AMPLIFIER on the

Home menu () first before reaching the amplifier

menu screen shown below (use the (cursor left/ right) soft keys to go to the previous/next menu screen).

AMPLIFIER 2/3

TV

AMPLIFIER CONT

				MIDNIGHT			DIGITAL NR
				TONE			LOUDNESS
				–	OPTION			+
				–	CH LEVEL			+
ACOUSTIC								CHLEVEL	SBCH
CAL.	MIDNIGHT	LOUDNESS	TONE	OPTION			DIGITALNR	INPUTATT SELECT	MODE
PHONES	SPSYSTEM	SIGNAL	VIDEO	TAPE2	STREAM	SETUP		VIDEOINPUT
	A/B	SELECT	SELECT	MONITOR	DIRECT	MIC	DIGITALIN
								S-VIDEO VIDEO	L AUDIO R

2Use the (OPTION) +/– buttons to adjust the amount of delay.

The delay can be adjusted from 0.0–6.0 frames (in 0.1 frame steps).

3Press ENTER to confirm.

Note

•When listening to an analog source, you can’t use sound delay when Stream Direct is on.

•One second is equal to 30 frames of NTSC format video, and 25 frames of PAL.

Watching video and audio sources independently

You can listen to a sound source and select a different video source on your TV.

•While listening to a source, press VIDEO SELECT to select the video source you want to watch.

With the remote, you may need to press AMPLIFIER on the

Home menu () first before reaching the amplifier

menu screen shown below (use the (cursor left/ right) soft keys to go to the previous/next menu screen).

En