●For continued safety, replace with a lamp assembly of the same type.
●Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.
●Do not drop the lamp module or touch the glass bulb ! The glass can shatter and cause injury.
Follow these steps to replace the lamp assembly.
1.Turn off the projector and allow the projector to cool thoroughly.
2.Disconnect the AC cord from the projector.
3.Remove 2 screws with a screwdriver and remove the lamp cover.
4.Remove 2 screws with a screwdriver and pull out the lamp assembly by grasping the handle.
5.Replace the lamp assembly.
6.Tighten 4 screws to secure the lamp cover to the lamp assembly.
7.Connect the detachable AC cord to the projector.
8.Reset the lamp replacement monitor timer.
(See "LAMP REPLACEMENT MONITOR TIMER" section on page 49.)
NOTE: Do not reset the LAMP REPLACEMENT MONITOR TIMER, except after the lamp is replaced.
52