Sanyo COMPUTER MODE, SELECTING COMPUTER MODE, SELECTING COMPUTER SYSTEM, MENU OPERATION, DIRECT OPERATION, AUTOMATIC MULTI-SCANSYSTEM

COMPUTER MODE

SELECTING COMPUTER MODE

DIRECT OPERATION

Press the MODE button on the projector or the COMPUTER button on the remote control unit to select Computer 1, Computer 2 Input.

The "Computer 1", or "Computer 2" display will appear on the screen for a few seconds.

		MENU OPERATION
	1	Press the MENU button and the ON-SCREEN MENU will
		appear. Press the POINT LEFT/RIGHT buttons to select
		Computer and press the SELECT (REAR CLICK) button.
		Another dialog box COMPUTER MODE Menu will appear.
2		Press the POINT DOWN button and a red-arrow icon will
		appear. Move the arrow to the mode either Computer 1 or

Computer 2, and then press the SELECT (REAR CLICK) button.

CURRENT MODE DISPLAY

MODE button

Computer 1

Computer 2

Video 1

Video 2

COMPUTER button

Computer 1

Computer 2

When selecting the Computer Mode, the Current Mode display appears to show the information of the computer being selected.

Providing the information of the computer detected by the projector.

SELECTING COMPUTER SYSTEM

AUTOMATIC MULTI-SCAN SYSTEM

This projector automatically tunes to most different types of computers based on VGA, SVGA, XGA or SXGA (refer to “COMPATIBLE COMPUTER SPECIFICATION” on page 37). When selecting Computer, this projector automatically tunes to the incoming signal and projects the proper image without any special settings. (Setting of the Computer System may be required when connecting some computers.)

Note : The projector may display one of the following messages.

Go to PC adj.	The projector cannot discriminate or detect the input
	signal from the computer. Adjust and set the
	computer system manually. (Refer to page 38.)
	There is no signal input from the computer. Make
No signal
	sure the connection of the computer and the

SYSTEM BOX

Display the SYSTEM being selected.

The system being selected.

projector is set correctly.

(Refer to TROUBLESHOOTING on page 53.)

If the incoming signal is digital, the "D-VGA", "D-SVGA", "D-XGA" or "D-SXGA" display appears.

SELECT COMPUTER SYSTEM MANUALLY

To set the Computer system manually, select the mode on the

ON-SCREEN MENU.

1	Press the MENU button and the ON-SCREEN MENU will
	appear. Press the POINT LEFT/RIGHT buttons to select
	SYSTEM and press the SELECT (REAR CLICK) button.
	Another dialog box COMPUTER SYSTEM Menu will appear.
2
	Press the POINT DOWN button and a red-arrow icon will
	appear. Move the arrow to the system that you want to set, and

then press SELECT (REAR CLICK) button.

The systems on this dialog box can be selected.

When this mark is displayed as black, more computer system modes will be available. Move the arrow to this mark and then press the SELECT (REAR CLICK) button, and the other modes will be displayed.

Close the SYSTEM Menu.

36