Preparation

q

Preparation

u y

qINPUT 4 (WARP & BLENDING board)

DIGITAL (DVI-D) (HDCP compatible)

Connect digital output signal from a computer or video equipment to this terminal with a DVI-D cable. (p23)

SERIAL PORT IN

When operating Warp and Blending feature, connect serial port of the computer and this terminal with a serial cross cable (commercially supplied). (p23)

SERIAL PORT OUT

When using Warp and Blending feature for more than two projectors from a computer connected to the SERIAL PORT IN terminal above, connect SERIAL PORT IN terminal on the other projector and this terminal with a serial cross cable (commercially supplied). (p23)

✔Note:

Refer to the enclosed operation manual for Warp and Blending in Advanced Screen Manager.

wINPUT 5 (Vacant for Optional Interface Board)

Optional interface board can be installed into this slot. This input accepts digital signals only. (p21, 75)

✽A built-in micro processor which controls this unit may occasionally malfunction and need to be reset. This can be done by pressing the RESET

button with a pen, which will shut down and restart the unit. Do not use the RESET function excessively.

w

t r e ✽

eR/C JACK

Connect the remote control to this jack with the supplied remote control cable to use the remote control as wired. (p26)

rUSB

Connect a USB mouse (commercially available) to control On-Screen Menu. (p26)

tUSB (Series B)

This port is used for the projector maintenance.

ySERIAL PORT OUT

This terminal outputs signal from SERIAL PORT IN. When controling more than two projectors from a computer, connect the other projector to this terminal with a serial cross cable (commercially supplied).

uSERIAL PORT IN

When controling the projector from a computer, connect the computer to this terminal with a serial cross cable (commercially supplied).

13